Idiomas disponibles
Idiomas disponibles
14. Troubleshooting
Fault
The appliance does not
start.
Water was not pumped
out of the dishwasher.
Fault
Foam in the
appliance
Blotchy appliance acces-
sories
White deposits inside the
appliance
Rust marks on the cutlery
Fault
Knocking/rattling noise in
the appliance
Technical faults
Possible cause
Fuse defective or circuit
breaker tripped
Appliance door is not fully
closed
Drain hose is kinked
Filter blocked
Siphon is blocked
General faults
Possible cause
Incorrect detergent
Detergent with colour ad-
ditives was used.
Mains water hard/high in
calcium carbonate
The cutlery in question is
not stainless.
No program was started
after adding salt.
Noise
Possible cause
The spray arm knocks
against the dishes and/
or against an item in the
dish rack or one of the
dishes is loose in the rack.
Solution
Change the fuse or switch on the circuit breaker again.
Make sure that the electric circuit is protected with at
least 10 ampere.
Switch the appliance on.
Close the door correctly.
Route the hose so that it is not kinked.
Clean the filter regularly.
Check the siphon. Make sure the outlet hose is proper-
ly installed.
Solution
Only use detergent that is suitable for household dish-
washers.
If foam has formed, open the appliance and wait ap-
prox. 20–30 minutes until the foam has receded.
Fill the water tank with 1.5 l water and allow the water
to drain manually.
If necessary, repeat the process several times until the
foam has been rinsed away.
Only use detergent without colour additives.
Clean the appliance with a little cleaner for dishwash-
ers using a damp sponge. Wear rubber gloves during
cleaning.
Always use only cleaners for household dishwashers.
Use only dishwasher-safe cutlery.
Always start the Quick program without dishes after
adding salt.
Solution
Stop the program and rearrange the dishes.
DE
FR
NL
ES
IT
EN
119
