Parkside PRM 1800 C3 Instrucciones De Utilización Y De Seguridad página 42

Cleaning / Maintenance / Transport / Troubleshooting
□ Check all connections (handlebars, cuttings collec­
tion bag 7 , etc.) for tight fit.
● Maintenance
As a rule, the device does not require maintenance
except for the measures described in the section entitled
"Cleaning and inspection after each use". There is no
need to lubricate or readjust any parts.
Additionally check once a year:
- Wheels 12 move easily.
- Functionality and ease of movement of the cutting
height adjustment 13 .
- Functionality and ease of movement of the
discharge flap 8 .
- Damage to the device (e.g. fractured housing parts
or worn cuttings collection bag 7 .
Contact customer service or a specialist workshop if you
find any defects. Do not operate the device once you
have found any defects.
● Transport
- Always transport the device with the handlebars
folded in (see Fig. G).
- Exclusively lift the device on the carry handle 15 .
- Exclusively transport the device in normal position;
prevent tilting while transporting.
- When transporting the device in vehicles, the
device must be secured in accordance with the
applicable regulations (load securing).
42 GB/IE/NI/CY/MT
● Troubleshooting
Problem Potential
cause
Motor does not Supply cable has
start. not been
connected prop­
erly.
Socket not ener­
gised/fuse or
circuit breaker has
tripped.
You have not
pressed the Start
button 1 and
the safety switch
.
3
Motor overload
protection has trig­
gered, motor is
overheated.
Device not running The selected
smoothly cutting height is
too low.
Device emitting
unusual noise
The cuttings collec­
Lack of output
tion bag 7 is
overfilled or the
discharge chute is
blocked.
Blades blocked by
foreign objects.
Blades blunt or
defective.
Remedy
Check the supply
cable has been
positioned
correctly.
Check the supply
cable for damage.
Proceed as
described in the
section entitled
"Switching the
motor on and off".
Let the device cool
down for 15-20
minutes.
Adjust the cutting
height 2 levels
higher.
Empty the cuttings
collection bag 7
and remove
cuttings from the
discharge chute.
Check the blades
compartment for
foreign objects
and remove any
foreign objects.
Check the blades
and have them
sharpened or
replaced at a
specialist work­
shop, if necessary.