Idiomas disponibles
Idiomas disponibles
-
If the ferromagnetic part only partially covers the base of the cookware, only the
ferromagnetic area will be heated, the rest of the base may not reach a sufficient
temperature for cooking.
-
If the ferromagnetic part is not homogeneous, but has other materials such as aluminium,
this may affect the heating and detection of the cookware.
-
If the base of the cookware is similar to Fig. 12, it may not be detected.
-
Do not use cookware with serrated edges or with a curved base. Fig. 13
-
Make sure the base of the cookware is smooth, flat against the glass, and of same size as
the cooking zone. Use cookware whose diameter is the same as the cooking area selected.
The use of a slightly wider cookware will increase the efficiency of the energy used. If you
use a smaller cookware, efficiency will be affected. The hob may not detect a cookware
smaller than 140 mm. Always place the cookware at the centre of the cooking zone. Fig. 14
-
Always lift the cookware off the induction hob, do not slide it, as it could scratch the glass.
Fig. 15
Start cooking
1. Hold down the power button for approximately 3 seconds. After turning on the hob, it will
beep and all the indicators will show - or - -, indicating the induction hob is on standby
mode.
2. Place suitable cookware on the cooking zone you wish to use. Make sure the bottom of the
cookware and the cooking-zone surface are clean and dry.
3. When pressing the cooking-zone selection button, the indicator next to the button will
flash.
4. Select a power level by sliding your finger on the slider:
-
If power is not selected within 1 minute, the hob will turn off automatically. You must turn
it on again and retry from step 1.
-
You can change the power setting at any time during cooking.
Fig. 16
Legend Fig. 16
1. To the right > increase
2. To the left > decrease
If in the display
This can mean:
-
You have not placed the cookware on the correct cooking zone.
-
The cookware you are using is not suitable for the induction hob.
-
The cookware is too small or is not correctly centred on the cooking zone.
If you do not place suitable cookware on the cooking zone, the latter will not heat up.
The display will turn off automatically after 1 minute if you do not place any cookware.
and the power setting flash alternately
ENGLISH
65
BOLERO SQUAD I 3250
