Parkside PWS 115 B2 Traduccion Del Manual De Instrucciones Originale página 36

GB MT
Removing the attachment
1. If necessary, remove the disc for better
access, see "Installing/changing disc".
2. Release the attachment (4.1) by
pushing the notch (13) away from the
guard cover (4).
3. Unscrew the attachment (4.1) from the
guard cover (4).
Installing/changing disc
1. Press the spindle stop button (6).
2.­ Turn­the­mounting­spindle­(11)­until­the­
spindle­lock­fi ­ xed­the­mounting­spind-
le. Keep and continue to hold down
the spindle lock button (6)
3. Release the clamping nut (10) with
the chuck key (8). You can release the
spindle lock button (6).
4. Set the desired disc onto the mounting
fl ­ ange­(
9). label on the disc should
always face the device.
If the rotary direction is in-
dicated on your disc, ensure
that it corresponds to the
rotary direction of the angle
grinder when mounting. This
is indicated on the device
next to the spindle stop but-
ton (6) (
­ Ensure­that­the­fl ­ ange­(
placed on the device in such a way
that­the­recesses­in­the­fl ­ ange­grip­
into­the­edge­of­the­device.­The­
mounting spindle (11) must turn simul-
taneously­when­you­turn­the­fl ­ ange.­
5. Set the clamping nut (10) on the moun-
ting­spindel­(11)­again.­The­fl ­ at­side­of­
the clamping nut must face the attach-
ment tool if the thickness of the disc
receptor is < 5 mm.
36
).
9) is
If­the­thickness­of­the­disc­receptor­is­≥­
5 mm, turn the clamping nut.
See illustration
6. Press the spindle stop button (6) and
turn the mounting spindle (11), until
the spindle toggle button holds the
spindle­fl ­ ange­in­a­fi ­ xed­position.­Pull­
the clamping nut (10) tight again using
the chuck key (8). You can let go of the
spindle lock button (6).
Installing/changing the
wire brush
1. Press the spindle stop button (6).
2.­ Turn­the­mounting­spindle­(11)­until­the­
spindle stop button holds the mounting
spindle­in­a­fi ­ xed­position.­Keep­the­
spindle stop button (6) depressed.
3. Release the wire brush with a combina-
tion wrench (not included in the scope
of delivery). You can now release the
spindle stop button (6).
4. Place the desired wire brush onto the
mounting spindle.
5. Press the spindle stop button (6) and
rotate the wire brush on the mounting
spindle­(11).­Tighten­the­wire­brush­
using a combination wrench. You can
now release the spindle stop button (6).
Operation
Caution! Risk of injury!
- Always remove the mains plug
before working on the tool.
- Only use grinding discs and acces-
sories recommended by the ma-
nufacturer. Using other attachment
tools and other accessories can
represent a risk of injury for you.
- Only use accessory parts which
bear information about the ma-
nufacturer, type of connection,
.