Sweeping System Lubrication Plan; Preparing For Maintenance Work; Maintenance Work - Kärcher MC 130 Manual De Instrucciones

Sweeping system lubrication plan

Lubrication point
1 Brush head lifting arm axle
2 Cylinder lifting arm axle
3 Swivel bearing lifting arm axle
4 Swivel bearing cylinder axle
ATTENTION
Malfunctions
Keep the V-belt clean and free of grease.
1 Use high-grade multi-purpose grease.
2 Lubricate the grease nipples in accordance with the lubricating
intervals (Table) using a grease gun.
Lubrication point
1 Swivelling cylinder lifting arm axle
2 Swivel bearing base support axle
3 Suction mouth cylinder support
4 Suction mouth cylinder basic body
5 Swivelling cylinder base support axle 1
6 Swivelling cylinder base support axle 1

Preparing for maintenance work

1. Park the vehicle on a level surface.
2. Switch off the suction fan.
3. Lower the side brushes.
4. Apply the parking brake.
5. Secure the vehicle against rolling away.
6. Switch off the ignition and remove the ignition key.
Risk of fatal injury from flowing road traffic
Bring the vehicle out of the hazard zone of flowing road traffic be-
fore starting any repair work.
Switch on the warning flashers.
Erect a warning triangle.
Don warning clothing.
Risk of injury and damage
Engine continues to run after switch-off.
Wait 5 seconds after switching off the engine.
Be sure to keep away from the working area during this period.
Risk of damage through incorrect cleaning
The articulated joint, tyres, radiator fins, hydraulic hoses and
valves, seals, electrical and electronic components must not be
Number Lubrica-
cleaned using a high-pressure cleaner.
of lubri- tion inter-
Observe the respective safety regulations when cleaning the ve-
cation val
hicle with a high-pressure cleaner.
points
Do not use aggressive cleaning agents.
1 each Every 8 h
Wash the vehicle only when the engine is switched off to protect
1 each Every 8 h
the air filter.
1 each Every 8 h
Risk of injury and damage
1 each Every 8 h
The vehicle may start up unexpectedly.
Always remove the ignition key and disconnect the battery before
performing any maintenance or cleaning work.
Risk of injury and damage
Maintenance work on the hydraulic system may only be per-
formed by specially trained personnel.
Risk of injury and damage
Always secure the tipping mechanism.
Danger of injury
Fully tip the waste container and lower the brush system/attach-
ment unit to relieve the hydraulic system of pressure during all

maintenance work.

The waste container can pivot to the rear. Always completely low-
er the waste container to the end position before performing work
underneath the waste container.
The waste container can lower unintentionally. Perform work on
the turbine only when the waste container is fully raised.
Danger of burns
Allow the vehicle to cool down sufficiently.
Number Lubrica-
Do not touch any hot components of the hydraulic system, hydro-
of lubri- tion inter-
static drive motor, internal combustion engine or the exhaust sys-
cation val
tem.
points
ATTENTION
1 each Every 8 h
Environmental pollution
1 each Every 8 h Do not allow fluids such as engine oil, hydraulic oil, brake fluid,
diesel or coolants to flow into the ground. Please protect the en-
1 Every 8 h
vironment and dispose of liquids in an environmentally-friendly
1 Every 8 h
manner.
Every 8 h
Every 8 h
Risk of injury and damage
Always secure the waste container when working with a raised
waste container.
English
Maintenance work
General safety instructions
DANGER
WARNING
CAUTION
WARNING
WARNING
CAUTION
DANGER
CAUTION
Securing the raised waste container
WARNING
87