Idiomas disponibles
Idiomas disponibles
Take out the battery for inspection in the following
order:
a. Turn off the power switch of the motorcycle
b. Remove the seat cushion
c. Remove the battery pressure plate
d. First remove the negative terminal (-) and then
remove the positive terminal (+)
e. Take out the battery gently, and install the battery
in the reverse order.
Warning
When reinstalling the battery, make sure that the
battery leads are connected correctly. If the battery
wires are connected reversely, the circuit system
and the battery itself will be damaged. The red line
must be connected to the positive terminal (+) and
the black line must be connected to the negative
terminal (-).
Be sure to turn off the power switch (key) when
checking or replacing the battery.
When replacing the battery, please pay attention
to the following
When replacing the battery, confirm the motorcycle
model and verify whether it is consistent with the
original battery model. The specification of the
battery is considered to be the best match in the
design of the motorcycle. If a different type of battery
is used, it may affect the performance and life of the
motorcycle, and may cause circuit failure.
Warning
The battery will produce flammable gas when it is
used and charged, so it should not be close to the
open fire or spark when charging.
The battery contains sulfuric acid (electrolyte),
which is highly corrosive, so it is necessary to
prevent the human body, clothes, vehicles, etc.
From contacting the electrolyte. In case of contact,
wash it with water immediately. In case of contact
with eyes, wash it with plenty of water immediately
and seek medical advice in time. Electrolyte
contact with the skin or eyes may cause severe
burns.
46
