Idiomas disponibles
Idiomas disponibles
Clamp
Fuel injector and oil circuit
There is an interface on the fuel pump ①, and the
fuel enters the fuel injector ② from one of the inter-
face pipes of the fuel pump, and the fuel injector
finally injects the fuel gas into the intake pipe of the
engine.
Please connect the oil inlet and return pipes as
shown in the figure.
The rated working pressure of the
fuel pump is 300kPa, and the work-
ing current is less than 2.2A.
The gasoline filter of the oil circuit
of the vehicle is integrated in the oil
pump. Do not use the fuel pump of
other specifications, so as not to
cause the fuel injector stuck and the oil circuit prob-
lems.
Lubrication of parts
Proper lubrication is very important to maintain the
normal operation of every working part of your
motorcycle, prolong its service life and drive safely.
After driving for a long time or after the motorcycle is
wet by rain or washed, we recommend that you
lubricate the motorcycle. See the figure below for
the key points of specific lubrication and mainte-
nance:
Lubricating oil for motorcycle
Y
Grease
Z
1 Rear brake pedal shaft
2 Side stand joint and spring hook
3 Shift pedal pin shaft
4 Throttle cable
Y
5 Front brake handle pin
6 Clutch handle (pin shaft)
44
Z
Z
Z
Z
Y
