Idiomas disponibles
Idiomas disponibles
Front
Brake fluid
After the friction plate
Front liquid cup
is abraded, the liquid in
the cylinder is auto-
matically injected into
the brake hose and the
liquid level decreases
accordingly. The front fluid reservoir is installed
above the right handle of the vehicle. If the liquid
level is lower than the mark MIN of the lower limit
scale line of the fluid reservoir, the specified brake
fluid shall be added as appropriate; The rear fluid
reservoir is installed in the middle of the right side of
the vehicle. It shall be ensured that the liquid level of
the rear fluid reservoir is between the MIN (or
LOWER) and MAX (or UPPER) scales. If the liquid
level is lower than the MIN (or LOWER) scale, the
specified brake fluid shall be added. Replenishing
the brake fluid should be considered a regular
service necessity.
Caution
Front
This vehicle uses DOT4 brake fluid. Do not use the
residual fluid from the cylinder opening and the
brake fluid left over from the last maintenance,
because the old fluid will absorb the moisture in
the air. Be careful not to splash the brake fluid on
Rear liquid cup
the paintwork or plastic surface, it will eat away the
surface of these substances.
Brake system
The brake system to be checked daily is as follows:
(1) Check the brake fluid volume in the front and rear
brake fluid reservoir.
(2) Check the front and rear wheel brake system for
leakage.
(3) Whether the brake handle and brake pedal have
proper travel and are always connected reliably.
(4) Check the wear condition of the friction plate. If
the notch on the bottom line of the groove is exceeded,
replace the two friction discs together.
39
