Idiomas disponibles
Idiomas disponibles
Coolant
Coolant Type: Soft water and
glycol-based engine specific
antifreeze coolant compatible
with aluminum radiators. Use
the
original
antifreeze
coolant.
Use
of
other
coolant/mixtures that do not
meet the requirements will
cause damage to the engine.
When the new vehicle leaves the factory, the
coolant has been installed, and attention should be
paid to the inspection of the coolant level in the
expansion pot during maintenance.
When the coolant becomes turbid or reaches the
maintenance cycle, please visit the local QJMOTOR
dealer service station to replace the coolant in time.
When the engine is turned off and cooled, check the
coolant in the expansion pot. During the inspection,
make sure that the motorcycle is on the horizontal
plane and the motorcycle body is vertical. The
expansion pot is located under the fuel tank.
Observe the coolant volume in the expansion pot
and make sure that the coolant volume is kept
between the MIN and MAX marks. If the coolant
level is below the MIN mark, remove the expansion
pot cap plug and add coolant, or add coolant at the
Expansion pot
cap plug
QJMOTOR dealership.
Warning
Do not add the coolant until the engine is turned off
and cooled. To avoid burns, do not open the
coolant filler cap until the engine has cooled down.
The cooling system is under pressure. In some
cases, the coolant contains substances that are
flammable and, when ignited, produce an invisible
flame. Since the combustion of the leaked coolant
will cause severe burns, it is necessary to avoid
the leakage of the coolant on the motorcycle parts
with high temperature.
Because coolant is a highly toxic liquid, avoid
contact with and inhalation of coolant, and keep it
away from children and livestock. If coolant is
inhaled, seek medical advice immediately. If skin
or eyes come into contact with coolant, wash
immediately with clean water.
42
