Idiomas disponibles
Idiomas disponibles
EnGLIsh
TROUBLESHOOTING
Problem
Solution
Unit will not start.
•
Check battery installation.
•
Check battery
charging requirements.
•
Check that lock off is fully pushed
down prior to moving main trigger.
Unit shuts down
•
Charge battery.
in use.
•
Unit is being forced. Restart and
apply less pressure.
Battery
•
Insert battery into charger until red
won't charge.
charging light illuminates. Charge up
to 8 hours if battery is totally drained.
•
Plug charger into a working outlet.
Refer to Important Charging Notes
for more details.
•
Check current at receptacle by
plugging an appliance.
•
Check to see if receptacle is
connected to a light switch which
turns power off when you turn out
the lights.
•
Move charger and appliance to
a surrounding air temperature of
above 4.5 °C or below 40.5 °C.
Bar /
•
Refer to Adjusting Chain
Chain overheated.
Tension section.
•
Refer to Chain Oiling section.
Chain is loose.
•
Refer to Adjusting Chain
Tension section.
Refer to Adjusting Chain
Poor cut quality.
•
Tension section. nOTE: Excessive
tension leads to excessive wear and
reduction in life of bar and chain.
Lubricate before each cut. Refer to
Replacing the Saw Chain section.
Unit runs but does
•
Chain could be installed backwards.
not cut.
Refer to sections for installing and
removing chain.
Unit does not oil.
•
Refill oil reservoir.
•
Clean guide bar, sprocket and
sprocket cover. Refer to Care And
Maintenance section.
50
