DeWalt DWE402 Manual De Instrucciones página 19

5.Continuously move t he tool i naforward and back motion toavoid
creating gouges inthework surface. Allowing thetool t orest o n
the work surface without moving, ormoving the tool i na circular
motion c auses burning and swirling marks onthe work surface.
6.Remove the tool f rom the work surface before turning t he tool o ff.
Allow the tool t ostop rotating before setting i tdown.
i_CAUTION:
Use extra care when working over an edge, as a
sudden sharp movement of grinder may be experienced.
Mounting and Using Type 1/Type 41
Cutting Wheels
NOTE: The Type 1 guard MUST be used and is available at extra cost
from your local dealer or authorized service center.
Cutting wheels include diamond wheels and abrasive discs. Abrasive
cutting wheels for metal and concrete use are available. Diamond
blades for concrete cutting can also be used.
i_ WARNING: A closed, two-sided cutting wheel guard is required
when using cutting wheels. Failure to use proper flange and guard
can result in injury resulting from wheel breakage and wheel contact.
See pages 10 and 11 for more information.
MOUNTING AND REMOVING (TYPE 1) ONE-TOUCH
TM
GUARD (FIG. 18)
Cutting wheels include diamond wheels and abrasive discs. Abrasive
cutting wheels for metal and concrete use are available. Diamond
blades for concrete cutting can also be used.
MOUNTING CLOSED (TYPE 1) GUARD
_ CAUTION: Turn off and unplug the tool before making any
adjustments or removing or installing attachments or accessories.
Before reconnecting the tool, depress and release the paddle switch
to ensure that the tool is off.
Your grinder is supplied with a keyless ONE TOUCH
TM
guard.
1. Press the guard release lever (J).
2. While holding the guard release lever open, align the lugs (L) on
the guard with the slots (M) on the gear case.
3. Keeping the guard release lever FIG.18 L
open, push the guard down until
the guard lugs engage and rotate
them in the groove on the gear
case hub. Release the guard
release lever.
4. With the spindle facing the operator,
rotate the guard clockwise into
the desired working position. The M N M
guard body should be positioned
between the spindle and the
operator to provide maximum
operator protection.
5. For easy adjustment, the guard
can be rotated in the clockwise j
direction.
NOTE" The guard release lever should snap into one of the
alignment holes (O) on the guard collar. This insures that the guard
is secure. The guard can be repositioned the opposite direction
by depressing the guard release lever.
6. To remove the guard, follow steps 1-3 of these instructions in
reverse.
18