Idiomas disponibles
Idiomas disponibles
installation
location
Do not install the appliance:
outdoors,
in an environment
with dripping water,
in rooms which are at risk of frost.
Appliance
is very heaw
for empty weight see the
following
table:
BM (Bottom
Mount) 36"
approx. 430 tbs / 195 kg
Installation
room
The appliance
should be installed in a dry, ventilated
room.
The ambient temperature
should not drop below 55 °F
(13 °C) or rise above 110 °F (43 °C), otherwise
malfunctions
may occur.
The installation
location should not be exposed
to direct
sunlight and not placed near a heat source, such as an
oven, radiator, etc. If installation
next to a heat source is
unavoidable,
use a suitable insulating plate or observe
the following
minimum
distances
from the heat source:
11/4" (30 mm) from an electric cooker,
12" (300 mm) from an oil or solid fuel cooker.
Installation
cavity
It is important
to observe the specified
dimensions
of
the installation
cavity for a trouble
free installation
of the
appliance
and for the subsequent
general view of the
furniture front.
[_ln
particular
ensure that the cavity is square.
Squareness
can be checked
by suitable means,
e.g. spirit level, diagonal measurements,
etc.
[_The
side walls of the cavity must be flush.
The minimum
thickness
of side walls and the top watt
must be 5/8" (16 mm).
The minimum
thickness
of toe kick panet must be
U2" (13 mm).
A thickness
of s/4"(19 mm) is recommended.
Furniture/fixtures
The new appliance
is screwed
securely to adjacent
and overhead
furniture/fixtures.
For this reason it is essential that all attachable
furniture/fixtures
are connected
securely to the
base or the watt by suitable means.
Base
A fully toad appliance
is very heavy
for the
toad bearing capacity
at least see the following
table:
BM (Bottom
Mount) 36"
approx.
1200 tbs / 540 kg
To ensure that the appliance
is installed securely and
functions
properly, the base must be flat and level.
The base must be made of a hard, rigid material.
The installation
area must be the same height as the rest
of the room.
On account
of the heaw weight of a fully loaded
appliance,
a toad bearing base is required.
If in doubt,
contact
an architect
or a building expert.
6
