Idiomas disponibles
Idiomas disponibles
C3
C3
Prevent the power cord from becoming
caught.
Tie a piece of string to the middle of the power cord
and feed forwards
under the appliance.
When
pushing
in the appliance,
pull the cable forwards.
or
Using adhesive tape, stick the power cord to the
floor centrally
behind the appliance
approx.
15"
(380 mm) away from the rear panel of the cavity.
Carefully push the appliance
into the cavity until
the height-adjustable
wheel interlock
with the
anti tip brackets.
C3 Remove edge protection.
10. Installing
and aligning the
appliance
6/4
38 mm
C3 Align the appliance
with the furniture fronts.
Place marking
out level over the installation
aid
parts on the door.
The installation
aid parts on the door have been
designed
for the following total thickness
of furniture
doors:
:_" (19 mm)
11/2" (38 mm)
Always take account
of the possible differing
thickness
of the furniture fronts which are to be
fitted subsequently.
The height adjustable
feet at the front and rear can all
be adjusted from the front.
Front:
with open ended wrench 1/2" (SW13)
Rear:
with 5/16" (8 mm) hex nut driver
via flexible shaft.
A mark is attached
to the appliance
base and is used as
a standard
gage for height adjustment.
When adjusting
the height, align this mark at a height of 1 '/4" (32 mm)
above the floor.
17
