Idiomas disponibles
Idiomas disponibles
•
Turn on the power using the "I/O" switch located on the back of the unit.
Load the dishes with the material to be processed and close the lid.
•
•
Press the "MENU" button on the control panel and then set the target
temperature and incubation time with the parameter increase/decrease
buttons.
•
Start the device with the "START/STOP" button.
To program one of the 9 available operating modes, press the "P" button and
•
then the "MENU" button. It will allow you to select the mode number in which
you want to save the program (1-9) and set the temperature and operating
time. After the parameters are saved, the device will remember them. All other
modes are saved in the same way.
To start a given operating mode, turn on the device, then press and hold the
•
"P" button to enter the programmed operation mode. Then press the "MENU"
button to select 1 of the 9 preset operating modes. The selected mode will
start automatically. After its completion, the device will go to the next saved
mode and start it, and so on, until all the modes that were programmed at that
time are completed.
•
IMPORTANT: the approximate heating time of the device from 25-100
approx. 12 minutes. Cooling down time from 15-0
minutes.
3.4.
Cleaning and maintenance
a)
Pull the mains plug and let the unit cool down completely before cleaning,
adjusting or replacing accessories and when the unit is not in use.
b)
Use only non-corrosive cleaning agents for cleaning the surfaces.
c)
After each cleaning, all the parts should be dried well before the unit is used
again.
d)
Store the unit in a dry and cool place protected from moisture and direct
sunlight.
e)
Do not spray the unit with a stream of water or immerse it in water.
f)
Make sure that no water enters through the ventilation openings in the casing.
g)
Clean the ventilation openings with a brush and compressed air.
h)
Use a soft, damp cloth for cleaning.
DISPOSAL OF WASTE APPLIANCES
At the end of its useful life, this product should not be disposed of with normal
household waste but should be taken to a collection point for the recycling of
electrical and electronic equipment. This is indicated by the symbol on the
product, operating instructions, or packaging. The materials used in this appliance
are recyclable according to their marking. By reusing, recycling, or applying other
EN
o
C is approx. up to 25
C is
o
