Steinberg Systems SBS-LAB-109 Manual De Instrucciones página 16

Baño seco de laboratorio
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 58
e)
If you cannot avoid using the product in a wet environment, use a residual
current device (RCD) to connect it to electrical mains. Using an RCD reduces
the risk of electric shock.
f)
Do not use the appliance if the power cord is damaged or shows signs of wear.
A damaged power cord should be replaced by a qualified electrician or the
manufacturer's service department.
2.2.
Safety in the workplace
a)
If you have any doubts as to whether the product is working properly or if it is
damaged, contact the manufacturer's service department.
b)
Repairs to the device may only be carried out by the manufacturer's service.
Do not attempt to repair the product on your own!
c)
In case of open flames or fire, use only dry powder or snow (CO2) fire
extinguishers to extinguish the live equipment.
d)
No children or unauthorized persons are allowed in the work area.
e)
Check the condition of the safety stickers regularly. Replace them if they are
illegible.
f)
Keep these instructions for use for future reference. If the product is to be
handed over to a third party, hand it over with this user manual.
g)
Keep the device away from children and animals.
2.3.
Personal safety
a) Do not operate this device if you are tired, ill, or under the influence of alcohol,
drugs, or medication that could impair your ability to operate the device.
b) The device is not intended to be used by persons (including children) with
reduced mental, sensory, or intellectual functions or persons who lack
experience and/or knowledge unless they are supervised or have been
instructed by a person responsible for their safety on how to operate the
device.
c)
The unit may be operated by persons who are physically fit, capable of
operating it, and appropriately trained, and who have read this instruction
manual and have been trained in occupational safety and health.
d) Use caution and common sense when operating this unit.
e) Use personal protective equipment as required when operating the unit as
specified in Section 1 of the explanation of symbols. The use of appropriate,
approved personal protective equipment reduces the risk of injury.
f)
To prevent accidental start-up, make sure the switch is in the off position before
connecting to a power source.
EN
loading