Idiomas disponibles
Idiomas disponibles
PROG: Enter into or exit the setting menu.
- and +: Function select and parameter adjust.
SET: Choose the selection, confirm the setting.
NOTE: Press the setting button for a short while (within 1 sec.) or long press the
button (over 2 sec.) will be for different functions.
MANUAL CONTROL MODE
In order to make sure that the first installation of this product succeeded, users
can test the opening/closing running under manual control mode. If there are any
abnormalities, please exit the manual control mode and re-adjust the gate, gate
opener and the limit switch.
Operation instruction:
• Press and hold "SET" button for 3 sec. and the indicator light L3 will flicker.
• Press "+" button to open the gate, then release "+" to stop running; Press "-"
to close the gate, then release it to stop running.
• Press "PROG" button once to exit the manual control mode and the indicator
light L3 will be off and system automatically exits the setting procedure.
NOTE:
• If there is no operation under the limit switch position setting for 60 sec.,
system will automatically exit the setting.
• If need to exit during setting, press "PROG" once to directly exit.
• Under manual control mode, if the gate didn't stop when it arrived at limit
switch, please exit the manual control mode, and check if the two magnet limit
switch stops are within the detection range of the magnetic limit switch.
QUICK SETTING FOR RUNNING TRAVEL
NOTE: before setting the running travel, please make sure that the gate is
completely open. Install the limit switch stops at limit switch position and make
sure the polarities are correct. After installation please do not move or remove it
anymore.
EN
