Idiomas disponibles
Idiomas disponibles
paragraph "Manual Control Mode"), then operate the motor to run to its open or
closed limit switch position to check if the limit switch can be well contacted.
WARNING: a bad contact between the limit switch and limit switch stops might be
dangerous, because it can cause the crash of the gate, damage the internal
structure of the motor, moreover, the gate may slide off the guide rail.
The limit switch stop magnet is designed to recognize the gate running direction
and its current position. During gate moving, the magnetic limit switch, which is
installed inside the motor, will detect the limit switch stops magnets when it
passes them and after detecting, the control board will store the gate running
direction and the limit switch stop position to enable the gate run to the set limit
switch position.
To change the gate opener from right-hand installed (default setting) to left-hand
installed, you should only set it on the control board, no need to switch the two
magnet limit switch stops. It's very important to choose the limit switch stops
position and make sure the polarities are correct.
Installation drawing of limit switch stop polarities for right-hand and left-hand gate
move operation:
(N) – black magnet
(S) – blue magnet
If you are not sure about the polarities of the two magnet limit switch stops are
correct, please operate it on the control board to enter into manual control mode,
and check if the gate will stop when it arrives at limit switch position.
Recommended installation height for the limit switch stop bracket:
EN
