Idiomas disponibles
Idiomas disponibles
•
Using a screwdriver loosen the screw on the side of the terminal.
Insert the bare wire ending into the number into the desired terminal you
•
want to connect.
•
Tighten the wire ending with a screwdriver to secure it in place.
TERMINAL DESCRIPTION
•
Terminal X7
ANT: extra antenna
GND: extra antenna grounding
COM: common terminal for external push button
STP: external stop push button switch
PED: external close push button switch
OSC: external open push button switch
Terminal X5
•
IR: photocell input common terminal for photocell (normally closed contact)
GND: ground
12V: Additional Accessories +12VDC, after gate closed in place, the board will
enter into low power consumption mode, this terminal will cut off the 12V power
supply
LAMP+: alarm lamp +12/24VDC
LAMP-: alarm lamp -12/24VDC
Terminal X6
•
EN
