Idiomas disponibles
Idiomas disponibles
@® REC (Record) LEVEL Control
(TAPE II only)
(See page 6.)
@© RECORD Button (TAPE II only)
(See page 6.)
To enter the record mode using the remote
control, press the two RECORD buttons
simultaneously.
@® BALANCE Control (TAPE II only)
(See page 6.)
@® PAUSE Button (TAPE II only)
@® PHONES Jack
Connect 8-ohm stereo headphones to this
jack for private listening or monitoring.
® REC (Record) MUTE Button
(TAPE II only)
(See page 6.)
® Display Button
If the DISPLAY button (on the remote
control only) is pressed, all display
indications will go out. Even if indications
are blank, each button remains operable.
Operations
Loading a Cassette Tape
1. Use your finger or a pencil to turn the
cassette's hub and take up any slack
tape.
Note:
Avoid
touching
the tape.
Fingerprints attract dust and dirt.
2. Press the eject button (4)* to open
the cassette compartment door.
3. Load the cassette tape with its open
edge facing down.
4. Gently close the compartment door.
"Notes:
eThe
cassette
holder
cannot
be
opened during recording or playback.
lf the power has been switched off
during play or recording, ejecting the
cassette may be impossible. In such a
case, switch the power on and press
the eject button again.
Tape Travel Depending on Setting of REV MODE Switch
Setting
Tape Travel
Beginning _ Side B
End
—
Start
Stop
When the tape reaches the end, playback or
—
Ses
sua
recording is released.
End
Side A
Beginning
® During forward play or recording, when
inning
Side8
the end of tape is reached, the direction
Beginning
@ End
of tape running is reversed to play or
Slstop
record in the opposite direction.
'Start
Reverse play or recording will continue
_—
© stor
to the end of the other side, at which
point play or recording is released.
End
;
Beginning
@® During reverse play or recording, when
Side A
the tape reaches the end, play or
recording is released.
PLAY mode (Tapes loaded in TAPE | or Il)
Beginning
i0¢8
During either forward or reverse play, when
eginning
End
the end of tape is reached, the direction of
tape running is reversed and play continues
in the opposite direction. In this way, the
two sides of the tape are played back
continuously, the tape will stop after 5
End
Sidea
Penning
cycles
PLAY mode (Tapes loaded in TAPE | and I!)
Continuous Playback Operation
TAPE!
TAPE II
®
®
Beginning
S9°8
= ® Eng
Beginning
Side8
End
Stop
= @
é
!Stop
start
dual
Start
End
Beginning
End
Beginning
oO
Side A
Side A
tt
®
@@®When
playback
starts
in the
(2) Controlis transferred to TAPE Il.
forward direction, at the end of
@ Playback starts in the forward direction;
tape, the tape is reversed to play
at the end of tape, it is reversed and the
the other side. At the end of this
other side is played back.
side, playback is released.
@ At the end of tape, control is transferred
®
back to TAPE |, which plays both sides.
® When
playback starts in the
reverse 'Greco, at the end of
This sequence ©—@ is repeated for 5
tape, TAPE lis released.
cycles
RECORD mode (TAPE II only)
ae
Side 8
Beginning
End
© Operation is same as =.
End
Sidea
Beginning
