Idiomas disponibles
Idiomas disponibles
b) Flexible hose or hose between the regulator and the stove
- Check the condition of the piping periodically and change it if
it shows signs of ageing or cracks or when national conditions
require it.
- In France, if the expiry date printed on the flexible pipes is
reached, the flexible pipe with collars must be replace by an
assembly complying with Standard XP D 36-110.
Possible problems / Corrective action
Possible problems
The burner does not light up
The burner does not burn smoothly or goes out
Unstable blowing flames
Large plume of flame on the burner surface
Flame at the injector
Burning leak around a union
Insufficient heat
Burning leak behind the adjustment knob
- Follow the assembly instructions supplied with these new
assemblies, whose length must be a maximum of 1.50 m, and
the procedure described in paragraph B).
- If you do not plan to use your stove for a long period, disconnect
the gas cylinder.
Probable causes / Corrective action
- Poor gas supply
- Regulator not operating properly
- Pipe, valve, venturi tube or burner holes obstructed
- Check that gas is present
- Check the pipe connection
- Contact your servicing agent.
- New cylinder may contain air. Allow the stove to operate and
the fault will clear itself.
- Residual water, following the washing of the burner caps.
- Contact your servicing agent.
- The venturi is obstructed (possibly cobwebs). Clean the venturi.
- Contact your servicing agent.
- The cartridge is almost empty
- Change the cylinder and the fault will clear itself
- Contact your servicing agent.
- Shut off the gas supply immediately
- Leaking union: tighten nuts or change pipe
- Contact your servicing agent.
- Injector or venturi tube obstructed
- Contact your servicing agent.
- Defective valve
- Shut down the stove
- Contact your servicing agent.
11
GB
