Idiomas disponibles
Idiomas disponibles
SECURITY / TRANSPORT, STORAGE & CLEANING /
2016/425, such as descender devices EN 341, positioning systems EN 358 or fall arrest systems EN
363. Adjustment devices on descender devices must be adjusted to the diameter of the rope.
Metal components must not include any burrs or sharp edges that might cause damage to the rope.
You put yourself at risk by combining equipment parts that impair the safe operation of any part of the
equipment or of the assembled equipment.
Before use, a plan for rescue measures must be prepared to take account of all possible emergenci-
es. Before and during use, you must consider how the rescue measures can be carried out safely and
effectively.
TRANSPORT, STORAGE & CLEANING
Low stretch ropes are usually made of polyamide fibres. The sheathing can also contain or be entirely
made of polyester fibres. Consequently, they should not be exposed to heat exceeding 100°C. If you
notice reactions such as discolouring or hardening, the product must be withdrawn for safety reasons.
The rope can shrink by up to 7% if exposed to humidity. Accordingly, the rope should always be pro-
tected against dirt and placed in appropriate packaging (rope bag) during transport. Place the rope in
the bag loosely and do not roll it up so as to avoid twisting.
Storage conditions:
dry and clean
at room temperature (15 – 25°C),
protected against the light (UV radiation, welding equipment, ...),
away from chemicals (liquids, vapours,
gases, ...) and other aggressive conditions,
protected against sharp-edged object.
A light-proof rope bag provides good protection.
To clean the rope, rinse it with lukewarm water and wipe with a damp cloth. The damp rope must be
dried before storage. The rope should be left to dry naturally and not close to a fire or other sources of
heat.
For disinfection, only use substances that have no influence on the synthetic materials used.
You put yourself at risk by not complying with these conditions.
REGULAR CHECKS
The equipment must be inspected regularly without fail: your safety depends on the effectiveness and
durability of the equipment.
After every use, check the rope for possible damage. Inspect the rope visually from all sides. Feel
along a seemingly intact rope (tactile check) in order to detect any hidden core damage that might have
been caused by frequent bending or local overloading. If there is visible damage to the sheathing, the
rope must not be used under any circumstances. If the rope shows swellings, discolouring or other
unusual changes, we recommend withdrawing the rope.
Check the eye of the termination with special attention: The stitching that prevents the termination from
gradually opening must be in place. The eye must not be longer than 25mm (length measured inside
the eye). After every use, the equipment should be checked for abrasion and cuts.
Systems that have been damaged or affected by a fall must be withdrawn from use immediately.
If there is the slightest doubt, the product must be withdrawn or inspected by an expert.
In addition, if the equipment is used in worker safety in accordance with the EN 365, it must be in-
spected by the manufacturer or an expert complying precisely with the instructions, and replaced if
necessary at least every 12 months. Records must be kept of this inspection (see table below).
REGULAR CHECKS
7
