Satellite Radio Tuner Control; Category And Channel Search; Channel Scan; Direct Access Tuning Using The Remote - Kenwood KDC-BT648U Manual De Instrucciones

Satellite Radio Tuner Control

Preparation : Only with the optional accessory Satellite radio tuner connected.
Press SRC to select "SIRIUS" or "XM".
1
2 Press BAND repeatedly to select a band
(SR1/ SR2/ SR3/ SR4 ; XM1/ XM2/ XM3/
XM4).
Press 4 / ¢ to search for a channel.
3
■
You need to register to the service provider
to receive the service by Satellite Radio.
Consult the service provider if "CALL ... TO
SUBSCRIBE" appears.
■
The radio may take a little time to start
receiving after you select the Satellite Radio
source.
■
If the signal reception fails, "ACQUIRING
SIGNAL"/ "NO SIGNAL" appears.

Category and Channel Search

Press to enter Category and Channel
1
Search mode.
Turn the volume knob to select a
2
category, then press to confirm.
3 Turn the volume knob to select a
channel, then press to confirm.
■
To return to the category select, press
■
To cancel the Category and Channel Search
mode, press and hold
26
English
■
Press and hold for about 2 seconds to memorize the current channel.
■
Press briefly to recall memorized channel.
.
.

Channel Scan

Press and hold
1
Every receivable channel is checked for 10
seconds.
Press to receives the current channel.
2
Direct Access Tuning using the
remote controller (RC-405)
Press DIRECT to enter Direct Access
1
Tuning mode.
"– – –" appears.
Press the number buttons to enter the
2
channel number.
Press 4 / +¢ to search for the
3
channel.
■
To cancel the Direct Access Tuning mode,
press .
■
If you make no button operation for 10
seconds, the Direct Access Tuning mode is
automatically canceled.
■
If you cannot receive any signal in the input
Channel due to bad conditions on radio
wave or other such problems, "ACQUIRING
SIGNAL"/ "NO SIGNAL" appears.
Using the remote controller (RC-405)
#FM+ : Selects band.
4 / +¢
: Selects channel.
1 – 6 : Selects preset channel.
to start Channel Scan.