cecotec BOLERO AGUAZERO 4201 E Manual De Instrucciones página 74

ENGLISH
Close the door.
-
Press the power icon.
-
Press and hold the Delay icon and then press the Programme icon for 5 seconds.
-
The appliance beeps and H flashes on the display (the factory setting is H4).
-
To change settings
Press the Delay icon.
-
Each time the icon is pressed, the set value increases by one level. When the H7 level is
-
reached, the display goes back to H0 (off).
Press the Programme icon. The chosen setting is now saved.
-
Contact your water supplier company for information on the hardness of the water
-
supplied.
Every cycle with a regeneration operation consumes additional 2.0 litres of water; the
-
energy consumption increases by 0.001 kWh.
Water hardness table
Water hardness
°Clark Range
0-8 soft
9-10 soft
11-12 medium
13-15 medium
16-20 medium
21-26 hard
27-38 hard
39-62 hard
2. Adding salt into the water softener
Always use salt intended for use with dishwasher.
NOTE: if your model does not have a water softener, you can skip this section.
Descaler
Water hardness changes from place to place. If hard water is used in the dishwasher,
-
limescale deposits will form on the dishes and cutlery.
BOLERO AGUAZERO 4201 E _4201 INOX E
74
mmol/l
0-1.1
1.2-1.4
1.5-1.8
1.9-2.1
2.2-2.9
3.0-3.7
3.8-5.4
5.5-8.9
Water regeneration
occurs every "x" Set value on
programme sequence
the machine
H0 Off
H1 13
H2 9
H3 7
H4 5
H5 4
H6 2
H7
1