PTG RDS/control Manual De Instrucciones página 17

Starting digital control
NOTE
Operating the central tire inflation system is only possi-
ble when the engine of the vehicle is running, because
air must be continuously supplied by the vehicle compres-
sor. Otherwise, the information displayed may be incor-
rect and system functionality may be limited.
To switch on the display, actuate the black toggle switch
on the bottom of the operating console.
The display shows first the software version, then the in-
troductory information, then an overview of the target
tire pressures for all adjustment circuits (= group of tires
with the same tire pressure) that are installed on the ve-
Software version
hicle. Each adjustment circuit is displayed in a row next
to the corresponding symbol (front axle, rear axle, trailer)
on the left edge of the screen. The target tire pressures
for field work (left) and road travel (right) are displayed.
Start-up information
The current pressure in the tires is not displayed until the
central tire inflation system is activated.
Start screen
Changing the units of measurement
To change the stored unit of measurement from psi to bar,
press and hold the button in the top right cor-
ner of the operating console, then press the but-
Changing the unit of measurement to psi
ton. Pressing again changes the unit of measurement back
to psi. Release the button to store the unit of
measurement.
Changing the unit of measurement to bar
17