Machine Assembly; Mounting Machine To Stand; Mounting Machine To Bench - RIDGID 535 Manual De Operador

535 Manual Pipe and Bolt Threading Machine
20.8"
38.1"
Figure 2 – No. 535 Machine Dimensions

Machine Assembly

WARNING
To prevent serious injury, proper assembly of the
Threading Machine is required. The following pro-
cedures should be followed:

Mounting Machine To Stand

1. The machine is designed to mount on the three uni- versal stands listed below.
Machine Stands
Model No. Cat. No. Description
100A 92457 Universal Leg & Tray Stand
150A 92467 Universal Wheel & Tray Stand
200A 92462 Universal Wheel & Cabinet Stand
Figure 3
NOTE: To attach a pre-1996 Model 535 Threading
Machine to a Model 100, 150 or 200 Stand, a
58007 Adapter Kit must be used.
2. Parts diagram and parts list for the stands are includ-
ed in the 535 Parts List.
3. Assemble stand with "inside" decals located towards
the inside of the stand (Figure 4).
4. Insert stand stop tabs into bottom of the legs as
shown in the detail drawing. Use the four (4)
x 2 1 / " hex bolts to secure the legs to the cross-mem-
2
ber. Adjust the two halves of the stand stop to the
535 (Rear)
Pre-2001
20.5"
Figure 4 – Stand Assembly
5. Insert axle into frame and secure it with a
6. Mount machine to the stand using four (4) bolts that
CAUTION
machines must be mounted through the appropriate
holes in the legs (Figure 4).

Mounting Machine To Bench

1. If a stand is not used, the machine should be mount-
to a stable stand or bench may result in tipping and
3 / " - 16
serious injury.
8
Ridge Tool Company
proper distance to fit into the rear legs on the stand.
The stand stop bracket is not required or supplied with
the No. 100 Leg and Tray Stand.
535-A/535
Manual - 2001
Detail Section
washer and nut. Position stand stop bracket so that
the end of the bracket is held in place by the axle
shaft. Slide a wheel onto the axle. Slide a flat wash-
er over the axle and install a cotter pin to hold the
wheel on the axle.
mount into each corner of the base.
For proper balance and operation, RIDGID
ed to a stable bench. To mount the unit on a bench,
use four (4) 5 / " bolts in holes provided at each corner
16
of machine base. Base dimensions are shown in
Figure 2.
Failure to mount the threading machine
WARNING
535 (Front)
Pre-2001
535-A/535
Manual - 2001
Spacer Block
4 Required
3 / " - 16 x 4" Bolt
8
4 Required
After 2001
use spacer block
1 / " lock
2
5