Specifications; Standard Equipment; Assembly; Assembling 918 To Bases For Various Machines - RIDGID 918 Manual

Groove Roll
Figure 1B – 918 Roll Groover

Specifications

Materials, Pipe...............Steel, Stainless Steel,
Aluminum and PVC
Capacity
Standard Groove
Roll Sets ......................2"-6" schedule 10 and 40
steel pipe
Optional Groove
Roll sets.......................8"-12" schedule 10 and 8"
Schedule 40* steel pipe
1-1/4" to 1-1/2" schedule 10
and 40 steel pipe
2" - 6" Copper Tube (Type K,
L, M, & DWV)
Refer to the Table I, II and III
for other materials and wall
thicknesses
Depth Adjustment..........Depth Adjustment Nut
Actuation .......................2 Stage Hydraulic Hand Pump
Stabilizer........................Manually adjusted, for 2 ½" to
12" Pipe
Mounting Bases
Available........................RIDGID 300 Power Drive
RIDGID 1224 Threading
Machine
RIDGID 535A/M Threading
Machine
RIDGID 300 Compact/1233
Threading Machine
Weight (918, 300 PD Base,
Stabilizer) ......................82 lbs. (37 kg)
Dimensions (918, 300 PD Base,
Stabilizer) (WxDxH ........35" x 14" x 17.5"
(889 mm x 356 mm x 445 mm)
*Do not use to groove 8" schedule 40 steel pipe harder than 150 BHN.
This may result in improperly formed/out of specification grooves.
999-998-946.10_REV. C
Depth Adjustment Nut
918 Roll Groover
When properly used, the Model 918 Roll Groov-
NOTI E
er is designed to make grooves in 1" - 12" pipe that are
dimensionally within the specifications of AWWA C606-15.
Improper use of this equipment can make out of specifi-
cation grooves and damage the pipe and equipment.
Selection of appropriate materials and joining methods
is the responsibility of the system designer and/or in-
staller. Before any installation is attempted, careful evalu-
ation of the specific service environment, including chem-
ical environment and service temperature, should be
completed. Selection of improper materials and methods
could cause system failure.
Stainless steel and other corrosion resistant materials
can be contaminated during installation, joining and form-
ing. This contamination could cause corrosion and pre -
mature failure. Careful evaluation of materials and methods
for the specific service conditions, including chemical and
temperature, should be completed before any installation
is attempted.

Standard Equipment

Refer to the RIDGID catalog for details on accessories
supplied with specific machine catalog numbers.

Assembly

WARNING
To reduce the risk of serious injury during use, fol-
low these procedures for proper assembly.
Assembling 918 to Bases for Various
Machines
1. Mount the 918 on appropriate machine base, aligning
with ½" holes. When installing on the 1224 base, in-
stall the spacer plate between the base and 918.
Insert two ½" bolts from underside of base and se-
curely tighten with ¾" Wrench.
2. Mount the hydraulic pump on the base and secure
with four ¼" bolts, securely tighten with
For the 1224 base, the pump bracket will need to be
mounted to the base, and the pump attached to the
pump bracket.
3. Mount the stabilizer on the base. Insert two
through the base and securely tighten with
key.
4. For the 1233/300 Compact, loosely attach the rail
clamp to the underside of the base.
5. See Figures For details.
7 / " wrench.
16
3 / " screws
8
5 / " hex
16
5