GE JVM1665 Instrucciones De Instalación página 8

Installation Instructions
PLACEMENT OF THE MOUNTING PLATE
REMOVING THE OVEN FROM THE
CARTON/REMOVING THE MOUNTING
PLATE
%
[]
Remove the turntable, installation instructions,
filters, exhaust Adapter, damper, shelf and the small
hardware bag. Do not remove the Styrofoam
protecting the front of the oven.
Fold back all 4 carton flaps fully against carton
sides. Then carefully roll the oven and carton
over onto the top side. The oven should be resting
in the Styrofoam.
Carton
[_ Pull the carton up and off the oven.
%
The mounting plate is attached to the back of the
oven. Remove the two screws holding it to the oven.
The plate will be used as the rear wall template and
for mounting the oven to the wall.
[_ Set the oven upright. Remove and properly discard
plastic bags and Styrofoam.
[_ Open the oven door and remove any packing
material, if present, from inside the oven.
F_ FINDING THE WALL STUDS
I i
Wall
Studs
i
C_nt_rj_i
[] Find the studs, using one of the following methods:
A. Stud finder - a magnetic device which locates nails.
OR
B. Use a hammer to tap lightly across the mounting
surface to find a solid sound. This will indicate
a stud location.
[_ After locating the stud(s), find the center by probing
the wall with a small nail to find the edges of the stud.
Then place a mark halfway between the edges.
The center of any adjacent studs should be !6"
or 24" from this mark.
[_ Draw a line down the center of the studs.
THE OVEN MUST BE CONNECTEDTO AT LEASTONE
WALL STUD.
8