Idiomas disponibles
Idiomas disponibles
The selection prompt message will automatically
reappear and three beeps will be heard either at the
end of the conversation or after approximately 30
seconds if there is no answer.
CALL BY DIALLING CODE
The code dialled on the calling module (and/or
optional additional keypad 1038/73) will appear on
the display. A beep will be heard each time a button
is pressed.
CALL TO:
Press the
button to call the apartment door phone
associated to the code.
The apartment door phone will ring for the
programmed time (from 1 to 5 seconds) with either
continuous tone (main calling module) or intermittent
tone (secondary calling module). Three beeps will
be heard to confirm that the call is being made.
Press the
button to make the door phone ring
again.
Press the cancel button X if you make a mistake
in the code. The number will be cancelled from the
display.
During the conversation, the following message will
appear on the display for three seconds and three
beeps will be heard if the door lock is operated:
The selection prompt message will automatically
reappear and three beeps will be heard either at the
end of the conversation or after approximately 30
seconds if there is no answer.
DIRECT CALLS
Calls to two special users can be made simply by
pressing the corresponding buttons on the 825/202
module, if fitted. You can call a concierge switchboard
1038/40 simply by pressing the
dialling a code or selecting a name). Alternatively,
you can press either of the two module 825/202
buttons (if fitted and suitably programmed).
22
DOOR
OPEN
23
DOOR
OPEN
button (without
ADDITIONAL CODES AND FUNCTIONS
The calling module with directory can manage three
distinct code groups:
• Calling codes (1-JJJJ)
These codes identify the apartment phone or video
phone. Do not dial zero before a code formed by
less than four digits/characters (e.g. dial "12A" and
not "012A"). Press the
code. This will also forward the call.
• Door opener codes (numeric ONLY: 1-99999999)
These codes can be used by residents and
authorised people to directly open the door. A lways
press the
button, enter the code and press
the
button again. The door opening code
will not appear on the display because the
button was pressed before entering the code.
Asterisks will appear instead:
LOCK REL. CODE
The door opener codes can be inhibited in predefined
time bands by means of an external timed switch
connected between terminals H and 0V.
• Special codes (1-JJJ)
These codes can be used to switch auxiliary
services on and off, e.g. staircase lights, garden
lights, etc. These codes must be preceded by a
zero to prevent the code from being displayed
and followed by pressing the
SPECIAL CODE:
These codes can also be used to read the status
of an input. The message "ON" or "OFF" will
appear on the display according, e.g.:
TERMINAL STATE:
For additional information, see the special decoder
Ref. 1038/80 instruction manual.
NOTE: Press the cancel button X if you make a
mistake when entering a code. The code on
the display will be cancelled.
button to end the calling
********
button:
0***
ON
DS1038-011B
