Idiomas disponibles
Idiomas disponibles
can be entered. Press the
selected character in the upper row of the display.
Up to 32 characters can be entered. The upper row
will be scrolled leftwards after the 16th character.
After this procedure, take the cursor to the shortcut
menu: <Esc><Del><End>. To do this, hold button ↓
pressed until the cursor is on the "E" in <Esc>. To
confirm the name, select <End> by means of the ↑
button and press the
Proceed in a similar way to enter the calling
code (from "1" to "JJJJ") and the door open code
associated to the name (numeric only, from 1 to
99999999):
Code:
<Esc><Del><End>O
Lock re:00000000
<Esc><Del><End>O
Select <Del> to correct mistakes. The last entered
character will be deleted. Select <Esc> on the
other hand to quit the procedure without saving the
entered data.
NOTE 1: An error message will appear if the name
has previously been stored.
NOTE 2: The following confirmation message will
appear if the entered code is stored:
Code present
Confirm? <Y><N>
Deleting/editing a name
Select either <CANC> or <EDIT> from the name
management menu. The following will appear:
FIND NAME
WITH ↑ OR ↓
Use ↑ or ↓ to scroll the names and reach the one
to be deleted/edited. Press the
delete (a confirmation message will appear) or edit
the item (the editing procedure is described in the
specific paragraph above).
NOTE 1: A door opener code associated to a name
will be deleted automatically along with
the name.
DS1038-011B
button to enter the
button.
button to either
CLEARING THE DIRECTORY
In some cases, you may need to clear all the
names from the calling module with directory (e.g.
to re-install a device in another building).
This procedure can be carried out either from the
terminal or the keypad.
Via the terminal
− After establishing a logical connection with the
required calling module (see "PROGRAMMING VIA
TERMINAL 1038/55-/56"), go to the following page:
<Names>
<Lock Rel.>
<Program>
<Cancel><Exit>
Select <Names> and press ↵. The
management menu will appear:
<Insert>
<Modify>
<Delete><Esc>
<REP-PT><PT-REP>
− Hold bs pressed for three seconds. The following
question will appear:
Complete
cancellation
of repertory?
<No>
ONLY the names (and not the door opener codes) will
be cleared. Select "Yes" and confirm by pressing ↵.
All the names will be deleted.
Via the keypad
− Enter "00" followed by the four digit configuration
password (NOT the name management code
management password). The main menu will
appear:
<LANGUAGE><CONF>
<ID><TEST><ESC>
button and 5 at the same time. The
− Press the
following will appear on the display:
Eliminate ALL?
− Answer "Yes" to delete both the door opener
codes and the names (see below) stored in the
<Yes>
<Y> <N>
name
31
