Chicco QUIZY I-SIZE Manual página 48

whether static or with a retractor, approved according to UN/ECE
Regulation no. 16 or other equivalent standards (Fig. 26).
c) Never fit the car seat to a vehicle seat that is only equipped with a
2-point safety belt (Fig. 27).
d) Make sure that the abdominal portion of the vehicle seat belt rests
correctly on the waist of the child.
e) If used in a vehicle equipped with rear vehicle seat belts with in-
tegrated air bags (inflatable seat belts), the interplay between the
inflatable portion of the seat belt and this child restraint system
could cause serious injury or death. When using the car seat in
vehicles equipped with rear vehicle seat belt with integrated air
bags (inflatable seat belts), follow the car manufacturer's instruc-
tion manual.
f ) The car seat can be fitted on the front passenger seat or on any one
of the rear seats. Never use this child car seat on vehicle seats facing
the sides or opposite to the direction of the driver's seat (Fig. 28).
g) Make sure that the buckle of the car's three-point belt is not too
far up. Otherwise, try to install the car seat on a different seat in
the vehicle.
HOW TO CLEAN THE FABRIC COVER
The child car seat's fabric cover can be removed and washed by hand
or in a washing machine at 30°C, while the reducer cushion can only
be washed by hand. Please refer to the cleaning instructions on the
fabric label which illustrates the following washing symbols:
Wash by hand
30° C
Machine washable at 30°C.
30° C
Do not bleach
30° C
Do not tumble dry
Do not iron
Do not dry clean
Never use abrasive detergents or solvents. Do not dry the fabric cover
within a dryer, let it dry without squeezing it.
The fabric cover must only be replaced with another cover approved
by the manufacturer, since it is an integral part of the child car seat
and, therefore, one of its safety elements.
WARNING! To ensure the safety of the child car seat, never use it with-
out its fabric cover.
To remove the fabric cover follow the instructions below:
Cover
• Detach the elastic bands located under the sitting area at the front;
• Detach the elastic bands located behind the sitting area;
• Free the plastic tabs located on either side of the seat;
• Pull the cover off.
Headrest
• Detach the elastic bands located behind the backrest at the top;
• Detach the elastic bands located behind the backrest at the top;
• Free the plastic tab located behind the headrest;
• Pull off the headrest.
HOW TO CLEAN THE PLASTIC AND METAL PARTS
Clean the plastic and coated metal parts with a damp cloth only. Nev-
48