AIDIAN QuikRead go Instrucciones De Uso página 15

Ocultar thumbs Ver también para QuikRead go:
Idiomas disponibles

Idiomas disponibles

Audio volume
The fourth step presented by the set-up wizard is
to adjust the volume levels:
1.
Adjust the keypad tone volume with the arrow
buttons.
2.
The volume of these sounds can be tested
with the Test button.
3.
Adjust the volume for the alert tones by using
the arrow buttons.
4.
The sound volume can be tested by means of
the Test button.
5.
Accept the selection by choosing Next.
Power save
Adjust the power save time to reduce power con-
sumption when the instrument is being powered
from the battery pack. A lower time increases the
operation time.
1. Choose the time after which QuikRead go
Instrument will enter sleep mode (hibernate)
2. Choose the functionality of the sleep mode.
Finishing the set-up process
You have now completed the set-up process.
You may start using the instrument or make
additional settings from Advanced set-up which
takes you to Measurement flow where you can ad-
just laboratory or work-routine settings.
4 PRINCIPLES OF OPERATION
QuikRead go Instrument measures the absor-
bance of the cuvette contents and converts the
resulting figure into a concentration value on the
basis of pre-set test-calibration data. The calibra-
tion data defining the overall assay curve are en-
coded on each cuvette label. This information is
transferred to QuikRead go Instrument automati-
cally during the measurement.
Assays are performed in accordance with the user
instructions accompanying QuikRead go reagent
kit. The results are available within minutes.
The instrument can be operated using a mains
power supply or a battery pack. It has USB sock-
ets for an external printer or barcode reader.
QuikRead go Instrument can be connected to a
remote laboratory or hospital information system
(LIS/HIS). The instrument uses a standards-com-
pliant data-transfer protocol. Contact your supplier
for more details.
Power
(on, off or sleep mode)
QuikRead go Instrument can be in any of the three
modes: on, off or sleep mode.
Turning the power on
To turn on the instrument, press the Power button
on the front panel. A light on the button is illumi-
nated when the instrument is powered on.
If nothing happens, ensure that the power is con-
nected or, if the instrument is operating from a bat-
tery pack, that the battery pack is charged.
After the Power button is pressed, the backlight
of the display comes on, the instrument starts up,
and the main menu appears.
Starting QuikRead go Instrument for the first time
opens a set-up wizard (see the "Set-up wizard"
section).
Turning the power off
To turn the instrument off, press the Power but-
ton and hold for approximately two seconds. The
instrument requests you to confirm the shutdown,
asking, "Do you want to shut down?" If Yes is cho-
sen on the touchscreen display, the instrument
will turn off. If a cuvette was inside the instrument
when the shutdown command was given, the cu-
vette will be raised and the instrument will ask you
to remove it.
Sleep mode
The purpose of sleep mode is to prolong the bat-
tery life while the unit is being powered from the
battery pack (available separately). Sleep mode is
activated when the instrument has been inactive
for longer than the time indicated in the personal
settings (see the section on Settings → Power
save operation). The sleep mode's functionality
can be "Full standby" or "Close lid only".
The instrument indicates that it is in sleep mode
via blinking of the Power button light.
To wake the instrument up, press the Power but-
ton.
PRINCIPLES OF OPERATION
15
loading

Productos relacionados para AIDIAN QuikRead go

Este manual también es adecuado para:

145218