Scheppach Compact 15t Traduccion Del Manual De Instrucciones Originale página 45

Environmental conditions
The product must work under the following environ-
mental conditions:
Mini-
mum
Temper-
5°C
ature
Humidity
When working below 5°C, the device should be idled
for approx. 15 minutes to allow the hydraulic oil to warm
up.
• The mains power connection is protected with a 16A
slow-blow fuse.
• The "RCD circuit breaker" must have a 30mA trip
rating.
Required accessories:
• Grease or spray oil
Not included in the scope of delivery.
10.1 Setting up the log splitter
m Attention!
Risk of injury from the log splitter tipping over. A
toppling log splitter can cause serious injuries and
damage.
Prepare the workplace where the device is to be lo-
cated:
• Create enough space to allow safe, trouble-free
working.
• The device is designed for working on level surfac-
es and must be set up securely on a level and firm
surface.
10.2 Checking the oil level (Fig. 1, 12)
m Attention!
Check the oil level prior to commissioning!
The hydraulic system is a closed system with an oil
tank, oil pump and control valve. There is already oil in
the system when delivered. Check the oil level before
the initial commissioning and regularly before commis-
sioning. An oil level that is too low can damage the oil
pump, refill with oil if necessary.
Note
The splitting column (2) must be retracted before the
check, the device must be level.
Maxi-
Recommended
mum
40°C 16°C
95% 70%
www.scheppach.com
1. Unscrew the bleed screw (15).
2. Wipe the oil dipstick (32) with a clean, lint-free
cloth.
3. Screw the bleed screw (15) back into the filler neck
until it reaches the stop.
4. Unscrew the bleed screw (15) and read the oil level
in the horizontal position. The oil level must be be-
tween min. and max. at the dipstick (32).
5. If the oil level is too low, top up as described in
section 12.5.
6. Then screw the bleed screw (15) back in.
10.3 Bleeding the hydraulic oil tank (14) (Fig. 12)
m Attention!
Bleed the hydraulic tank before starting the log
splitter.
Note
If the hydraulic tank (14) is not bled, the trapped air will
damage the seals and therefore the log splitter!
1. Before starting work, it is essential to loosen the
bleed screw (15) by two turns to ensure air circula-
tion in the hydraulic oil tank (14).
2. Leave the bleed screw (15) loose during operation.
3. Before you move the log splitter, close the bleed
screw (15) again, since oil can run out otherwise.
Attention!
• When working below 5°C, the device should be idled
for approx. 15 minutes to allow the hydraulic oil to
warm up.
• Before transporting the device, it is essential to tight-
en the bleed screw to prevent oil leakage.
Functional check
Carry out a functional check before every use.
Action
Press the control lever on
the right (5) and the control
lever on the left (18) down.
Release the right operating
lever (5) or the left
operating lever (18).
Release the control lever
on the right (5) and the
control lever on the left
(18).
Actuate the stop lever
lever (21).
Result
The splitting wedge
(3) drives down.
The splitting wedge
(3) remains in the
selected position.
Splitting wedge (3)
moves back to the
upper position.
The splitting wedge
(3) remains in the
selected position.
GB | 45