Idiomas disponibles
Idiomas disponibles
7. Use scissors to remove any entangled
hair around the brushrolls. Clean any
debris from the brushrolls and the nozzle
cover.
8. Replace the brushroll assembly into the
nozzle cover at the required angle as
shown. Loop the new belt around the
motor shaft and the belt path on the
brushroll. The teeth of the belt and the
belt path must align with each other.
Make sure the washers are replaced
properly.
Motor
Shaft
Belt Path
9. Reinstall the belt end cover over the
motor shaft and the belt ends of the two
brushrolls. Make sure the belt ends are
fully inserted into the belt end cover.
BELT CHANGING
Washers
- 22 -
10. Press the brushroll assembly down
back into the nozzle cover. Rotate
the brushrolls to make sure the belt is
installed correctly.
11. Reinstall the two small covers and
secure with the three screws. Do not
over-tighten the screws.
