Idiomas disponibles
Idiomas disponibles
USING THE CARPET CLEANER WITH HOSE & TOOL
6. Turn on the carpet cleaner by pushing
the power button with your foot.
NOTE:
The brushrolls do not rotate when
the carpet cleaner is in the upright locked
position.
7. Hold the tool about 1 inch over the stain
to be cleaned. Squeeze the spray trigger
to spray a generous amount of cleaning
solution over the soiled area. Use the
brush on the tool to agitate stains by
scrubbing in a back and forth motion.
Spray
Trigger
8. To lift away the stain, apply downward
pressure on the front of the cleaning tool
and pull the tool backward slowly to
vacuum up excess dirty liquids. Repeat
as necessary.
9. Empty the dirty water tank when the
dirty liquid reaches the "Max Fill"
line and there is a loss in suction. See
instructions in the EMPTYING DIRTY
WATER TANK (page 16).
10. When finished cleaning with the hose
and tool, it is suggested to rinse the
inside of the hose and tool by turning
the carpet cleaner on to suck up warm
clean water.
11. Once you have completed cleaning,
push the power button again to turn the
carpet cleaner off; unplug the power
cord plug from the outlet.
12. Detach the hose and the tool. Be sure
the end of the cleaning solution delivery
tube is removed from the cleaning
solution outlet. Press both the hose
release clips to remove the hose from
the nozzle.
13. Close the flexible hose door.
- 15 -
