Idiomas disponibles
Idiomas disponibles
ENGLISH
Put the test paper
into water for about
1 sec. Do not put the
test paper under
running water.
The colours of the test paper continue to change. Do not check water hardness later
than 1 min after test.
You can change the water hardness level in the menu: Settings / Setup / Water hardness.
The table shows water hardness range (dH) with the corresponding level of Calcium deposit
and the water classification. Adjust the water hardness level according to the table.
Water hardness
Level
dH
1
0 - 7
2
8 - 14
3
15 - 21
4
≥22
When the tap water hardness level is 4, fill the water drawer with still bottled water.
Daily use
Warning! Refer to Safety
chapters.
How to set: Heating functions
Step 1
Turn on the oven. The display shows the default heating function.
Step 2
Press the symbol of the heating function
Step 3
Select the heating function and press:
Step 4
Set: temperature. Press:
Step 5
Press:
Food Sensor - you can plug the sensor at any time before or during cooking.
Shake the test paper
to remove the excess
of water.
Test paper
.
.
After 1 min, check
water hardness with
the table below.
Calcium deposit
Calcium depos‐
(mmol/l)
0 - 1.3
1.4 - 2.5
2.6 - 3.8
≥ 3.9
to enter the submenu.
. The display shows: temperature.
Set the water hardness
level: Menu / Settings /
Setup / Water hard‐
ness.
Water classifi‐
it (mg/l)
cation
0 - 50
51 - 100
moderately
hard
101 - 150
hard
≥151
very hard
92
soft
