Idiomas disponibles
Idiomas disponibles
4. Loosen the 2 rubber clamps (A) and move the
transport wheel forward.
B
5. Install the locking pins (B) for the transport wheel on
the right and the left side.
6. Disengage the drive wheels. Refer to
disengage the drive wheels on page 12 .
7. Tilt the product by the handle until all 3 wheels are
on the floor.
8. Push the product slowly.
To move the product up and down a
ramp
WARNING:
move the product up and down ramps with
the motor on. The product is heavy and
there is a risk of injury if the product falls
or moves too quickly.
WARNING:
slope, always use a winch. Do not stay
below or near the product.
WARNING:
on steep slopes. Look at the rating plate
on the product for information about the
maximum slope angle.
•
To move the product down a ramp, operate the
product rearward slowly.
•
To move the product up a ramp, operate the product
forward slowly.
•
Do not turn the product more than 45° on a ramp.
1804 - 003 - 28.08.2023
A
To engage and
Be very careful when you
For ramps with a steep
Do not move the product
To lift the product
WARNING:
equipment has the correct specification to lift
the product safely. The rating plate on the
product shows the product weight.
WARNING:
or near a lifted product. Keep bystanders
away from the risk area.
WARNING:
product. Make sure that the lifting point is
correctly installed and not damaged.
WARNING:
the handlebar, motor or chassis.
1. Remove the tool or attach the blade protection
cover.
WARNING:
with Kevlar. The blades are very sharp.
2. Make sure that the drive wheels are engaged. Refer
To engage and disengage the drive wheels on
to
page 12 .
3. Attach the lifting equipment at the lifting point.
4. Lift the product slowly.
Make sure that the lifting
Do not walk or stay below
Do not lift a damaged
Do not lift the product by
Use protective gloves
23
