Mitsubishi Electric TPKA0A.1KA Serie Manual De Instalación página 15

6. Electrical work
Fig. 6-19
Fig. 6-21
Function table (Table 1)
Select unit number "Grp."
Mode
Power failure automatic recovery
Indoor temperature detecting
LOSSNAY connectivity
Power voltage
Select unit numbers 1 to 4 or "All"
Mode
Filter sign
Fan speed
Fan speed during the cooling thermostat is OFF
*1 When the power supply returns, the air conditioner will start 3 minutes later.
*2 Power failure automatic recovery initial setting depends on the connecting outdoor unit.
Fig. 6-20
B
Fig. 6-22
Settings
Not available
Available
Indoor unit operating average
Set by indoor unit's remote controller
Remote controller's internal sensor
Not Supported
Supported (indoor unit is not equipped with outdoor-air
intake)
Supported (indoor unit is equipped with outdoor-air intake)
230 V
208 V
Settings
100 Hr
2500 Hr
No filter sign indicator
Silent (low ceiling)
Standard
High ceiling
Setting fan speed
Stop
Extra low
6.3.2. By wireless remote controller
1 Going to the function select mode
Press the button between of 5 seconds.
(Start this operation from the status of remote controller display turned off.)
[CHECK] is lighted and "00" blinks. (Fig. 6-19)
Press the button to set the "50".
Direct the wireless remote controller toward the receiver of the indoor unit and
press the button.
A
2 Setting the unit number
Press the button to set unit number A. (Fig. 6-20)
Direct the wireless remote controller toward the receiver of the indoor unit and
press the button.
3 Select a mode
Press the button to set Mode number B. (Fig. 6-21)
Direct the wireless remote controller toward the receiver of the indoor unit and
press the button.
Current setting number:
4 Selecting the setting number
Use the button to change the Setting number C. (Fig. 6-22)
Direct the wireless remote controller toward the receiver of the indoor unit and
press the button.
5 To select multiple functions continuously
C
Repeat select 3 and 4 to change multiple function settings continuously.
6 Complete function selection
Direct the wireless remote controller toward the sensor of the indoor unit and
press the
Note:
Make the above settings on units as necessary.
• Table 1 summarizes the setting options for each mode number.
• Be sure to write down the settings for all functions if any of the initial set-
tings has been changed after the completion of installation work.
*1
1=1 beep (1 second)
2=2 beep (1 second each)
3=3 beep (1 second each)
button.
Mode no. Setting no. Initial setting
1
01
2 Ο *2
1 Ο
02 2
3
1 Ο
03 2
3
1 Ο
04
2
Mode no. Setting no. Initial setting
1 Ο
07 2
3
1
08 2 Ο
3
1
27 2
3 Ο
setting
setting
14