Idiomas disponibles
Idiomas disponibles
Retrieving para-
Press the Info button several times in a row to display the parameters in the
meters during
following sequence:
charging
Example: current battery
voltage
Interrupting
Press Start/Stop button to interrupt charging:
charging
Charging deep-
In the case of deep-discharge batteries (voltage < 2 V), charging must be started manu-
discharge batte-
ally as follows:
ries
1.
2.
3.
4.
5.
6.
7.
8.
9.
1.
Disconnecting
2.
the battery
3.
Example: current charging
current
-
-
WARNING! Risk of serious damage as the result of
-
incorrectly connected charging terminals. The terminal polarity reversal
facility is inoperative in „Charging deep-discharge batteries back-up"
mode.
-
incorrectly set battery voltage.
Connect charging terminals to correct poles and ensure proper electrical
connection to vehicle terminals. Note battery voltage.
CAUTION! Risk of damage when attempting to charge a faulty battery. Before
charging, ensure that the battery to be charged is fully functional.
Plug in charger mains plug
Set mode
Set battery capacity
Connect the battery
Press and hold Start/Stop button for approx. 5 sec. - „Charging deep-discharge
batteries/back-up mode" menu item is activated
Select battery voltage by pressing Up/Down buttons
Example: 12 V vehicle voltage
Confirm selected voltage by pressing Start/Stop button
Confirm correct terminal connection prompt by pressing Start/Stop button
Charging begins
Press Start/Stop button
Disconnect (-) terminal from battery
Disconnect (+) terminal from battery
Example: ampere-hours
already charged
The display shows the number of ampere-hours already
charged
Press Start/Stop button again to resume charging
If no buttons are pressed within 5 seconds, the charger
returns to the main menu.
5
