Controls And Components - RCM GO Serie Manual De Uso Y Mantenimiento

Multifunction display (1)
(battery operated machine with drive system)
Shows the working hours of the machine, provides information about
the battery charge status and the fault diagnosis.
(See also "DASHBOARD AND ELECTRONIC CONTROL BOARD" -FIG.12)
Battery charge status light (2)
(battery operated machine without drive sytem)
Provides information about the battery charge status.
Green light = batteries charged.
Yellow light = battery charge running out.
Red light = batteries fl at.
Starter key-switch (3)
(battery operated machine with/ without drive system) . Turns on all the
electrical controls.
Switch on "0": controls off .
Switch on "1": controls on.
Vacuum push-button (4)
Turns on the vacuum motor.
(for the drive system machine, see also DASHBOARD AND ELECTRONIC
CONTROL BOARD" - Fig.12)
Brush push-button (5)
Starts the brush rotation motor.
(for the drive sytem machine, see also DASHBOARD AND ELECTRONIC
CONTROL BOARD" - Fig.12)
Brushes up/down pedal (6)
(battery operated machine with/ without drive system) . Used to raise/
lower the brushes.
Position "A" pedal raised - brushes down
Position "B" pedal down - brushes up
Solution on/off and regulator lever (7)
Turns on/off and regulates the fl ow of solution onto the brushes.
Squeegee up/down lever (8)
Used to raise/lower the squeegee.
Squeegee (9)
Used to suck up the dirty solution and dry the fl oor cleaned by the
brushes.
A= Front rubber strip
P= Rear rubber strip
CONTROLS AND COMPONENTS (FIG.2)
41
1
4
4
4
2
8
7
A A
9
P P
A A
P P
3
5
5
5
7
8
6
9