Replacing bulbs
In order to approach to the headlamp bulbs, follow the
procedure as under:
Remove the four screws "A" from the lower part of the
handlebar.
Push the speedo cable upwards & disconnect from
speedometer.
Lift the cover "B" disconnect the harness sockets and
remove the handle bar top cover. Take out the bulb holder
and replace the bulb.
For assembling of the cover "B" follow the reverse
procedure.
Head lamp setting
Place the unloaded vehicle on a level floor at
10 meters from a twilight white screen and take care
that the vehicle axis is perpendicular to the screen.
Drawn a horizontal line "b-b" at a height of "B" from the
ground corresponds to 0.9xC with the headlamp
switched on the low beam position, the horizontal line
of demarcation between the dark zone and the lighted
one should not be over the horizontal line.
Note: The operation of headlamp setting can be
carried out also with the driver only sitting on the
machine. In this case, of course, the beam alignment
should be altered whenever the scooter is being ridden
by both driver and passenger.
B=Cx0.9-C = Height from the ground to headlamp
centre.
B=Cx0.95 when the setting of the headlamp is carried
out with the vehicle at 5 meters from the screen.
85
