Scheppach HC550TC 400V Traduccion Del Manual De Instrucciones Originale página 30

16.4 Check the oil level at regular intervals (Fig. F)
Place the compressor on a level and straight surface.
The oil level must be at the centre of the oil sight glass
(16) (red dot).
16.5 Oil change (Fig. L)
The first oil filling must be changed after 10 operating
hours; afterwards, perform an oil change every 50
operating hours.
Switch the motor off and unplug the mains plug from
the power outlet. Remove the oil drain screw (15).
Additionally open the oil plug (18).
To prevent the oil from running out in an uncontrolled
manner, hold a small metal chute under the opening
and collect the oil in a vessel. If the oil does not drain
out completely, we recommend tilting the compressor
slightly.
Once the oil has fully drained out, replace the oil drain
screw (15).
Dispose of the old oil at a drop-off point for old oil.
To fill in the correct quantity of oil, make sure that the
compressor stands on an even surface.
Remove the oil plug (18) and add new oil through the oil
filler hole until the oil level in the oil sight glass (16) has
reached the correct quantity (red dot).
Do not exceed the maximum filling quantity. Overfilling
the equipment may result in damage.
Reinsert the oil plug (18) in the oil filler hole.
16.6 Cleaning the air filter
The air filter prevents dust and dirt being sucked in.
It is necessary to clean this filter at least every 300
operating hours.
A blocked air filter significantly reduces the compressor
power.
Remove the air filter by opening the wing nut (27) on
the air filter housing (1). Remove the wing nut (27) and
washer (28).
Then draw out the air filter housing (1). Draw the air
filter housing (1) apart. You can now remove the air
filter. Carefully knock out the air filter and the parts of
the filter housing.
These components must then be blown out with
compressed air (approx. 3 bar) and reassembled in
reverse order.
30 | GB
16.7 Connections and repairs
Connections and repair work on the electrical
equipment may only be carried out by electricians.
Please provide the following information in the
event of any enquiries:
• Type of current for the motor
• Data of machine type plate
• Data of motor type plate
Service information
With this product, it is necessary to note that the
following parts are subject to natural or usage-related
wear, or that the following parts are required as
consumables.
Wearing parts*: Air filter, V-belt, cylinder, piston, piston
rings, plastic clips
* may not be included in the scope of supply!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.
17. Disposal and recycling
The device is supplied in packaging to avoid
transport damages. This packaging is raw
material and can thus be used again or can be
reintegrated into the raw material cycle.
The device and its accessories are made
of different materials, such as metals and
plastics. Take defective components to special waste
disposal sites. Check with your specialist dealer or
municipal administration!
Old devices must not be disposed of with
household waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
handed over at the intended collection point. This can
be done, for example, by returning it when purchasing
a similar product or delivering it to an authorised
collection point for the recycling of old electrical and
electronic devices.
www.scheppach.com