Kärcher ICC 1 S D Manual Del Usuario página 25

Before Commissioning
Parking brake/ foot brake
Note
The appliance is fitting with a foot brake that
can also function as a parking brake.
Switch to operating mode "Parking
brake" (P).
Press the brake pedal.
Press brake pedal and keep it de-
pressed.
Switch to operating mode "Foot brake".
Unloading
Note
The appliance is fitted with tension belts,
ropes or chains for safe transport.
To unload the machine, proceed as follows:
Lock parking brake.
Remove the tension belts, ropes or
chains from the transport eyelets.
The machine can be moved in 2 ways:
(1) By pushing it (see Moving sweeper with-
out engaging self-propulsion).
(2) By driving it (see Moving sweeper by en-
gaging self-propulsion).
Moving sweeper without engaging
self-propulsion
Unscrew rear cover.
Shift freewheel lever (pushing opera-
tion).
Note
Do not move the machine for long distances
without engaging self-propulsion, a speed
of 10 km/h should not be exceeded.
Moving sweeper by engaging self-
propulsion
Shift freewheel lever (driving operation).
Start up
General notes
Park the sweeper on an even surface.
Remove ignition key.
Lock parking brake.
Refuelling
Danger
Risk of explosion!
– Only use the fuels specified in the Oper-
ations Manual.
– Do not refuel the machine in enclosed
spaces.
– Smoking and naked flames are strictly
prohibited.
– Ensure that no fuel reaches the hot
open surfaces.
Switch off engine.
Open fuel filler cap.
Only diesel appliances: Fill in diesel.
Only petrol device: Use regular unlead-
ed petrol.
Fill in the tank up to a level 1 cm below
the lower edge of the filling nozzle be-
cause the fuel expands on heating.
Wipe off any spilt fuel and close fuel fill-
er cap.
Fuelling using a can
– Estimate the fuel requirement in order to
avoid overflows.
Fuelling using the fuelling gun
– Insert the fuelling gun as deep as possi-
ble into the fuel nozzle. Do not add any
more fuel once the fuelling gun stops
according to the settings.
Inspection and maintenance work
Check engine oil level.
Check the hydraulic oil level.
Check water cooler and maintain it.
Check tyre pressure.
Adjust driver's seat.
Check suction blower channel.
Check setting of suction opening.
Check lights and ensure that they are
functioning properly.
Check signaling and warning systems
for proper functioning.
Fill the water reservoir.
Note
For description, see section on Care and
maintenance.
Warning
Rectify any defect you may find immediate-
ly or bring the vehicle to a halt.
Operation
Adjusting driver's seat
Pull seat adjustment lever outwards.
Slide seat, release lever and lock in
place.
Check that the seat is properly locked in
position by attempting to move it back-
wards and forwards.
Set the inclination of the back-rest..
Release back-rest.
Pull upward the unlocking lever of the
back-rest.
Change the inclination of the back-rest
via the position of the upper body.
Release unlocking mechanism.
Adjust engine speed
Rough tuning
Press button.
– Drawn out: max. speed
– Pushed in: min. speed
Fine tuning
Turn the button.
– In clock-wise direction: min. speed
– Anti-clockwise direction: max. speed
Starting the machine
Sit on the driver's seat.
Do not press the accelerator pedal.
Lock parking brake.
Engine speed adjustment - pull out 1/3
Pre-heating (only diesel appliances)
Turn the ignition key to position "I".
Pre-heat lamp glows.
Start motor (only diesel appliances)
When the pre-heating lamp goes off,
turn the ignition key to position "II".
If the machine starts, release the igni-
tion key.
25
English