Kärcher ICC 1 S D Manual Del Usuario página 26

Start motor (only petrol appliances)
Pull out the choke.
Turn the ignition key to position "II".
Release the ignition key when motor
starts up.
Push the choke slowly back when motor
is running.
Note
Never operate the starter motor for longer
than 10 seconds. Wait at least 10 seconds
before operating the starter motor again.
Drive the machine
Engine speed adjustment - pull it out ful-
ly.
Press brake pedal and keep it de-
pressed.
Switch to operating mode "Foot brake".
Drive forward
Press slowly the accelerator pedal "for-
ward".
Reverse drive
Danger
Risk of injury! While reversing, ensure that
there is nobody in the way, ask them to
move if somebody is around.
Press slowly the accelerator pedal "re-
verse".
Note
Driving method
– A warning tone is sounded while revers-
ing.
– The accelerator pedal can be used to
vary the driving speed infinitely.
– Avoid pressing the pedal suddenly as
this may damage the hydraulic system.
– In the event of power loss on inclined
surfaces, slightly reduce the pressure
on the accelerator pedal.
– Change the driving direction only after
the vehicle has come to a halt.
Brakes
Release the accelerator pedal, the ma-
chine brakes automatically and stops.
Note
The braking effect can be supported by
pressing the foot-brake.
Driving over obstacles
Warning
Raise the side-brushes and the suction
opening before overtaking hurdles.
Hurdles up to 150 mm in height:
Bypass the hurdle slowly and carefully
at an angle of 45°.
Hurdles more than 150 mm in height:
26
English
Only drive over these obstacles using a
suitable ramp.
Warning
Risk of damage! Ensure that the vehicle
does not get stuck up.
Sweeping mode
Danger
Risk of injury! If the bulk waste flap is open,
stones or gravel may be flung forwards by
the roller brush. Make sure that this does
not endanger persons, animals or objects.
Warning
Do not sweep up packing strips, wire or
similar objects as this may damage the suc-
tion blower unit.
Warning
To avoid damaging the floor, do not contin-
ue to operate the sweeping machine in the
same position.
Note
To achieve an optimum cleaning result, the
driving speed should be adjusted to take
specific situations into account.
Note
During operation, the waste container
should be emptied at regular intervals.
Raise/lower side-brushes
Press the lever to the front Side-brush-
es and suction opening will be lowered.
Note
The side-brushes are switched on automat-
ically.
Pull the lever towards the rear. The side
brush and the suction opening are
raised.
Adjusting the side-brush speed
Adjust the side-brush speed using the
lever.
Turn on/off the spray water
Press spray water button.
Spray water for side-brushes and suction
opening gets activated to bind the dust.
Regulate water quantity in the suction
channel
Adjust the water flow to the suction
channel using the regulation valve.
Regulate the water flow to the side-
brushes.
Adjust the water flow to the side-brush-
es using the regulation valve.
Turn on/off the suction blower
Press suction blower button.
Note
The water pump runs only when the suction
blower is switched on.
Sweeping in larger objects
Note
The operator can view his working area
through the mirror of the suction opening.
Raising bulk waste flap: