Idiomas disponibles
Idiomas disponibles
wood and CLAMPED OR HELD FIRMLY TO THE FENCE TO KEEP
IT FROM ROLLING PARTICULARLY WHEN MAKING ANGLE CUTS.
MAINTENANCE
(Perform all maintenance with miter saw unplugged.)
1. All bearings are sealed. They are lubricated for life and need no
further maintenance.
2. Periodically clean all dust and wood chips from around AND
UNDER the base and the rotary table. Even though slots are
provided to allow debris to pass through, some dust will
accumulate.
3. The brushes are designed to give you several years of use. If
they ever need replacement follow the instructions in this manual
or return the tool to the nearest service center for repair.
IMPORTANT
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustment (including brush inspection and replacement) should
be performed by authorized service centers or other qualified service
organizations, always using identical replacement parts.
Trouble Shooting Guide
BE SURE TO FOLLOW SAFETY RULES AND INSTRUCTIONS
TROUBLE! SAW WILL NOT START
WHAT'S WRONG?
1.Saw not plugged in.
2.Fuse blown or circuit breaker tripped.
3.Cord damaged.
4.Brushes worn out.
If you have any questions, call 1-800-54-HOW-TO
TROUBLE! SAW MAKES UNSATISFACTORY CUTS
WHAT'S WRONG?
1.Dull blade.
2.Blade mounted backwards.
3.Gum or pitch on blade.
4.Incorrect blade for work being done.
TROUBLE! BLADE DOES NOT COME UP TO SPEED
WHAT'S WRONG?
1.Extension cord too light or too long.
2.Low house current.
TROUBLE! MACHINE VIBRATES EXCESSIVELY
WHAT'S WRONG?
1.Saw not mounted securely.
2.Stand or bench on uneven floor.
3.Damaged saw blade.
TROUBLE! DOES NOT MAKE ACCURATE MITER CUTS
WHAT TO DO...
WHAT'S WRONG?
1.Plug in saw.
1.Miter scale not adjusted correctly.
2.Replace fuse or reset
2.Blade is not square to fence.
circuit breaker.
3.Blade is not perpendicular to table.
3.Have cord replaced by
4.Workpiece moving.
authorized service center.
4.Have brushes replaced
by authorized service
center.
18
WHAT TO DO...
1.Replace blade.
2.Turn blade around.
3.Remove blade and
clean with turpentine
and coarse steel wool
or household oven
cleaner.
4.Change the blade.
WHAT TO DO...
1.Replace with adequate
size cord.
2.Contact your electric
company.
WHAT TO DO...
1.Tighten all mounting
hardware.
2.Reposition on flat level
surface.
3.Replace blade.
WHAT TO DO...
1.Check and adjust.
2.Check and adjust.
3.Check and adjust fence.
4.Clamp workpiece to
fence or glue 120 grit
sandpaper to fence with
rubber cement.
