Home Decorators Collection 56237 Guía De Uso Y Mantenimiento página 15

Assembly - Preparing the Remote Control
Preparing the remote control
NOTE: The remote control has already been paired to the ceiling
fan for your convenience. If you have two of the same model fans
in your home, please follow the steps below to control each fan
independently.
NOTE: The remote control battery will weaken with age and should
be replaced before leaking takes place, as this will damage the
remote control. Dispose of used battery properly and keep the
battery out of the reach of children.
□
Confirm that the power to the fan is off at either the wall switch or
breaker box.
□
Remove the battery cover by pressing firmly on the arrow and sliding
the cover off.
□
Install two 1.5V AAA batteries (R).
□
Return power to the fan at the wall switch or breaker box.
□
If the remote control doesn't work as normal, press then release
the "Learn" button for 1-2 seconds, located in the remote's battery
compartment, within 30 seconds of turning on the power.
□
If pairing is successful, the blades will begin to spin.
□
Replace the battery cover on the remote control.
1 to 3 mode
□
To use more than one remote control for your fan, press the "Learn"
button for 10 seconds and release within 30 seconds of turning on the
power. Once pairing is successful, the blades will begin to spin.
□
Repeat the above process for the remote controls you want to work
with this fan.
□
The fan can be only controlled by 3 remote controls maximum at the
same time after "Learning". If you use a fourth remote control to
handle the fan, the first remote control will be replaced.
1 to 1 mode
□
To use only one remote control for your fan, press and release the
"Learn" button for 1-2 seconds within 30 seconds of turning on the
power. The "1 to 3" mode will be cleared and returned back to "1 to 1"
mode.
Assembly - Attaching the Accessories
Mounting the remote control holder
NOTE: Screw wall anchors are included for extra support. The
included screws are designed to screw easily into the wall. If
you would like a more permanent or secure hold, install the wall
anchors prior to attaching the wall cradle to the wall.
□
Slide the screw cover plate up to remove it from the wall
cradle.
□
Position the wall cradle in the desired position and attach it to
the wall using the included wall cradle screws.
□
Slide the screw cover plate back onto the wall cradle to
conceal the screws.
1
0
Screw cover plate
15
Please contact 1-800-986-3460 for further assistance.
1
0
HOMEDEPOT.COM/HOMEDECORATORS