Idiomas disponibles
Idiomas disponibles
Operation
Setting the torque target zone
The target zone enables the torque wrench to be tested in a defined
tolerance range. The tolerance range is specified as a percentage
e.g. ±4 %. This percentage refers to the target torque which has
been entered. The target torque set on the DPG must be identical to
the torque set on the torque wrench.
During the test
The available LEDs are used to show whether the torque wrench has
triggered within the target zone.
If the yellow LED lights up after triggering, the lower tolerance range
has not been reached. The torque wrench must be readjusted.
If the green LED lights up after triggering and an acoustic signal is
heard, the tolerance range has been adhered to. The torque wrench
is correctly adjusted.
If the red LED lights up after triggering and an acoustic signal is
heard, the upper tolerance range has been exceeded. The torque
wrench must be readjusted.
A target zone of 4 % is set as default. The target zone can be
set to values between 1 % and 10 %. If you do not want to use
this function, it can also be switched off.
78
