Working Environments; Automatic Position Search (Rpa) - Mondolfo Ferro MT 2450 Manual De Uso

WORKING ENVIRONMENTS

This balancing machine allows three different operatives to work at the same time,
since three different working environments are provided.
To recall a working environment, proceed as follows:
- Press any of the keys, and then press the key within two
seconds.
- This preselects service program N° 87 (indicated in the display on the left).
- press key to confirm the selection;
If the presetting is not confirmed within about three seconds, the system automatically
exits from the functions programs environment.
- "OP" (operator) will appear on the left-hand display, with "1" on the right-hand one;
- press the key to select the operator (1, 2 or 3);
- confirm the selection of the new operator by pressing the key.
When a new operator is selected, the machine activates the parameters saved
previously in that specific working environment.
The parameters memorised are:
- Balancing function active (trucks / cars).
- Balancing mode; dynamic, Alu, static.
- Wheel dimensions; distance, diameter and width or those relating to the active Alu.
- OPT; last passage of the OPT function.
N.B.: the optimisation procedure can only be carried out by one operator at a time.
The machine's general settings remain the same for all the working environments:
grams/ounces, sensitivity x1/x5 (x10/x50), threshold, etc.

AUTOMATIC POSITION SEARCH (RPA)

When the automatic position search program is active, at the end of each balancing
wheel spin the machine stops the wheel in the position for application of the inside
weight; if no weight is required, the wheel is stopped in the outside weight application
position.
Pressing the START key with the guard raised activates automatic position search for
the other side of the wheel.
To access the automatic position search program, proceed as follows:
- recall the function program N° 87 (Working environments) by pressing the
78 MT 2450 operator's manual