Installation; Important; Fitting The Head; Anchoring The Machine To The Floor - Mondolfo Ferro MT 2450 Manual De Uso

WARNING
Carry out the unpacking, assembly and installation operations described in this
heading with great care.
Failure to observe these instructions may result in damage to the machine and
injury to the operator or other persons.
Remove the original packing material, after having positioned it as shown on the
outside and keep intact so that the machine can be safely shipped at a later date if
necessary.
WARNING
The regulations in force concerning safety at work must be complied with when
choosing the installation position.
In particular, the machine must only be installed and used in protected
environments where there is no risk of dripping onto it.
IMPORTANT: for correct, safe use of the equipment, users must ensure a lighting level
of at least 300 lux in the place of use.
Ambient conditions in place of operation:
- relative humidity from 30% to 80% (without condensate);
- temperature from 5° to +40°C.
WARNING
The machine must not be operated in potentially explosive atmospheres.
If the machine is supplied with a number of separate parts that require assembly,
follow the assembly procedures described below.
- Unscrew the support (A, fig.5A) from the base (B, fig. 5A) undoing the two fixing screws
(A, Fig.5).
- Fix the support (A, fig. 5A) on the base (B, fig. 5A) using the included screws.
- Pay attention to the cables connected to the display when handling the support.
- Turn the wheel balancer on.
Anchoring the machine to the floor (fig.7)
- After completing assembly of the machine, place it in the chosen position, making
sure that at least the spaces left in figure 10 are left around it.
- Mark the floor at the points where the fixing holes have to be made (A, B fig. 7).
- Drill holes in the floor with a drill-bit of suitable diameter, insert the expansion plugs
and position the machine in line with the holes.
- Fix the left-hand front foot (B fig.7), fitting the screws and the relative washers in the
order shown in the diagram.
- Tighten the screw until the rubber foot and PVC washer are slightly compressed.
- Then secure the right-hand side of the machine by means of the two holes on the
cross-beam (lift side, A fig. 7).
MT 2450 operator's manual

INSTALLATION

Fitting the head (fig. 5-5A)
GB
53