Idiomas disponibles
Idiomas disponibles
Take care not to scratch the Kapton film.
So that removal of the object is as easy as possible, wait until the print bed has cooled.
If necessary, you can also remove the build plate from the printer to remove the object�
To do this, loosen the fixing clasps on the front right and left of the print bed and remove the build plate.
When reinserting, ensure that the build plate has been inserted in the correct end position and that the
fixing clasps are closed.
An incorrectly seated build plate can cause misprints or damage to the printer.
10.2
Actions during USB printing
When printing using a USB flash drive, you can intervene in the following ways:
•
: Stop
•
: Settings / optimization
•
: Pause next layer
•
: Pause
10.2.1 Stop
⇒ To cancel printing, press the stop
♦ A confirmation prompt asks you whether you really want to cancel the printing
process�
⇒ To resume printing, press the left arrow
♦ Printing continues without further interruption�
⇒ To cancel printing, press the stop
♦ Printing is stopped immediately�
♦ The print head heating and print bed heating are switched off.
♦ You are in the main menu (Fig. 9).
⇒ Select the AXES
⇒ Move the print bed down a little
up to that point�
Caution! Danger of burns!
The print head and print bed could still be hot. Wear protective gloves!
⇒ Remove the object�
10.2.2 Settings / optimization
By repeatedly pressing the settings/optimization button
following settings:
• Temperature
• Printing speed / flow rate
• Backlight / brightness of the display
• Object fan control
• FMS settings
Changes you make here overwrite the settings in the G-code�
Caution!
In Renfert mode, the printing parameters are stored for a perfect printing result. All of the nec-
essary settings for orthodontic applications are optimally pre-configured and tailored to the
filament. This ensures a high level of process reliability and simplicity. Changing these settings
modifies the pre-installed parameters. In this case, Renfert does not guarantee printing quality.
button�
�
button again�
menu (Fig. 9) and the axes icon
(Z+) in order to be able to remove the object that has been printed
- 27 -
in that menu:
, you can make successive changes to the
en
Fig. 59
Fig. 60
