Scheppach PL55 Traduccion Del Manual De Instrucciones Originale página 33

Vibration emission level (3 directions)
Typical weighted vibrations a
R: 1.108 m/s²
Uncertainty K
7. Before starting the equipment
• Open the packaging and remove the device care-
fully.
• Remove the packaging material as well as the pack-
aging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for transport
damage.
• If possible, store the packaging until the warranty
period has expired.
m ATTENTION!
The device and packaging materials are not toys!
Children must not be allowed to play with plastic
bags, film and small parts! There is a risk of swal-
lowing and suffocation!
• It must be possible for the blade to run freely.
• When working with wood that has been processed
before, watch out for foreign bodies such as nails
or screws, etc.
• Before you press the ON/OFF switch check that the
saw blade is fitted correctly. Moving parts must run
smoothly.
• Before you connect the equipment to the power sup-
ply make sure the data on the rating plate are identi-
cal to the mains data.
• Only connect the machine to a correctly installed
protective contact socket, with fuse protection of at
least 16A.
Electrical connections
Check that the electrical system to which the machine
is connected is earthed in compliance with current
safety regulations and that the current socket is in per-
fect condition.
The electrical system must be fitted with a magne-
to-thermal protective device to safeguard all conduc-
tors from short circuits and overload.
The selection of this device should be in line with the
following electrical specifications of the machine stated
on the motor.
= F: 1.239 m/s²,
h
= 1.5 m/s²
www.scheppach.com
NOTE: Your plunge saw's electrical system is equipped
with an under-voltage relay which automatically opens
the circuit when the voltage falls below a minimum
pre-established limit and which prevents the self-reset
of machine functions when voltage returns to normal
levels.
If the machine stops involuntarily, do not be alarmed.
Make sure that there has not been a voltage failure in
the electrical system.
8. Settings
m WARNING! Risk of injury! Electric shock
Always pull the mains plug out of the socket before per-
forming any type of work on the machine!
Adjusting the cutting depth (Fig. F)
The cutting depth can be adjusted from 0 to 55 mm.
Unfasten the cutting depth adjustment screw (7) and
set the required depth using the scale for depth of cut
(2) and retighten the screw.
The sawing unit can now be pressed down to the set
cutting depth.
The dimensions on the scale for depth of cut (2) shows
the cutting depth without rail.
Adjusting the cutting angle between 0° and 45°
(Fig. G)
The mitre square can be set from 0° to 45°.
Unscrew the mitre adjustment screws (14) on both
sides.
Swivel the sawing unit to the desired cutting angle
(Scale for mitre square (6)).
Tighten the mitre adjustment screws (14) on both sides.
Note: Both positions (0° and 45°) are set at the factory
and can be readjusted by the after-sales service team.
Changing the saw blade (Fig. A-D, H, I)
m CAUTION! Risk of injury! Hot and sharp tools
Do not use insert tools that are blunt or defective. Wear
protective gloves.
m Warning! Risk of injury! Electric shock
Always pull the mains plug out of the socket before per-
forming any type of work on the machine!
GB | 33